FEYNLAB® PLASTIC transforms faded dull exterior trim back into a deep rich looking finish. PLASTIC grants a new chemical structure which adds UV protection from future fading.
Once PLASTIC is Fully Cured, it is recommended to top with Topcoat for extra protection and hydrophobics.
Durability & Application Surfaces:
Durability – 1 yr.
Application includes 1 component layer, reaching an overall film build between 1-2 microns.
APPROVED SURFACES FOR APPLICATION ONLY: – DO NOT apply to unapproved surfaces
- Exterior textured plastics
- Exterior plastic bumpers
Shelf Life:
Unopened – 1 year. Opened – Use within 7 days. ALWAYS keep cap on bottle when not in use.
Included:
30ml (1oz) FEYNLAB® PLASTIC
Cautions:
Always wear respirator & gloves during application. Ensure application area is free of loose contamination.
Surface Preparation:
Thoroughly clean vehicle using FEYNLAB® PURE WASH vehicle to remove all topical contamination. Follow with a topical decontamination clay treatment using FEYNLAB® PRIME.
Directions:
Prior to application place vehicle in a well lit, temperature controlled 10°C-30°C (50°F-85°F), & contamination
free environment.
Shake PLASTIC vigorously for 1 min before use.
Application Instructions:
- Using the microfiber applicator, apply a small amount of PLASTIC and work into the surface. The amount of product should be enough to evenly coat the area without over saturation.
- Allow plastic to dwell and seep in for 5 min or apply as much as needed in a 5 minute window.
- After 5 min, go back to starting place and wipe any excess product to even out surface.
Note: The amount of product required will vary based upon the overall composition of the plastic trim type and the starting condition. More oxidized faded trim may require more product for restoration. For extremely faded plastic use FEYNLAB®PLASTIC BLACK.
Final Inspection:
Be sure to carefully inspect all finished panels for any leftover coating residue (high spots) during the final wipe. Commonly edges, emblems, and other tight areas may contain some remaining residue. High spots are much easier to remove if caught within a 20-40 min window after the final wipe, than later when the coating has set and curing has started.
Post Application Instructions:
- HIGHLY RECOMMENDED: Cure surfaces in the sun right after application as long as possible.
- Avoid any incidental water exposure for 4 hours. If it occurs, gently wipe water off the surface.
- Avoid all chemicals including car washes for 7 days.
Climate Notes:
All FEYNLAB® Coatings are subject to different dwell and curing time windows due to humidity and temperature. In General, the higher the humidity level the quicker the coating will cure. If humidity level approaches 80% or higher then consider lessening the recommended dwell and wipe times for the coating.
If possible apply coating in temperature controlled environment 10°C-30°C (50°F-85°F), with humidity as low as possible.
Reviews
There are no reviews yet.